
Rev. 1.00 12-02-13 23/41
General Notes
Factory Configuration and Default Startup Configuration
The SmartNodes as delivered from the factory contain both a factory configuration and a default
startup configuration. While the factory configuration contains only basic IP connectivity settings, the
default startup configuration includes settings for most SmartWare functions. Note that if you press and
hold the system button (Reset) for 5 seconds the factory configuration is copied onto the startup
configuration (overwrite). The default startup config is then lost.
IP Addresses in the Factory Configuration
The factory configuration contains the following IP interfaces and address configurations bound by the
Ethernet ports 0/0 and 0/1.
interface eth0
ipaddress dhcp
mtu 1500
interface eth1
ipaddress 192.168.1.1 255.255.255.0
mtu 1500
Commenti su questo manuale