Zeck Audio STAC Force180 Guida di Installazione Scaricare il pdf (Pagina 14)

Rev. 1.00 12-02-13 14/41

The software upgrade procedure for the G.S interface card has been improved and now gives a

complete error description in case of a failure at any point during the procedure.

11987 Removed support for hardware version 4.x for SN4552, SN4562, SN4554, S-DTA

Due to limited memory resources this software build cannot be downloaded anymore to

SN4552, SN4562, SN4554 and S-DTA devices with hardware version 4.x or lower.

Build Series 2012-03-15

11560 Web interface generates a new identity

An issue arises on the SmartWare web interface when a user clicks the hyperlink of a newly

created identity containing special characters like „+‟ etc. This causes creation of a duplicate

identity with a name identical to the originally created identity but with its special character (here

„+‟) replaced by a space character. This issue is now fixed and identity names on SmartWare

web pages may now contain such special characters (+, # etc.).

11638 PPPoA on G.S interface

It is now possible to configure the PPPoA protocol on SmartNodes with a G.S interface. This

feature requires the software version G.12 to be loaded on the G.S interface. Refer to the

section New Configuration Commands for a detailed description.

11722 SN-Web page refresh causing reboot

In case of a web page reboot the process got stuck at the page “reboot-prog.html”. This page is

responsible for executing the “reload forced” SmartNode command. If somebody tries to reload

this page in the browser (e.g. with the F5 button) the reboot will happen over and over again.

Now after executing the restart command the browser will immediately go to the home page

where reloading the page will not result in a reboot anymore.

11766 Enhance DSL status display

When the “show dsl status” command was executed on a SmartNode with a G.S interface, then

the parameter name “Cell Delineation” was misleading. It has now been renamed to “Loss Of

Cell Delineation”. Additionally in 4-wire mode the state of the second port was not displayed

even if it holds valuable information. The original “Port State” parameter has been renamed to

“Port State 1” and the new second port state has been introduced as “Port State 2”.

11773 DTMF Caller-ID reception on FXO

The SmartNode analog devices now support DTMF caller IDs on FXO ports. The following

standards are supported:

- ETSI (ETS 300 659-1 Annex C)

- Denmark (TDK-TS 900 216)

- India (NO.SR/ASF-01/03)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 40 41

Nessun commento

Zeck Audio STAC Force180 Guida di Installazione Pagina 14