Zeck Audio STAC Force180 Guida di Installazione Scaricare il pdf (Pagina 17)

Rev. 1.00 12-02-13 17/41

11842 SN5200 hardware-version 6.X support

For the SN5200 device, hardware-version 6.X support has been added.

11844 CED-Tone Net Side Detection not working

The command ced net-side-detection had no effect. This has been fixed and the command has

been enhanced as described for 11780 above.

The command modem detection on-remote-fax-request was not working correctly. This has

been fixed.

Only the 2012-01-26 build series are affected by these two problems (earlier build series are

working).

11848 Crash when downloading G.S firmware with web interface

SmartNode crashed when a new G.S firmware was applied using web interface. This failure has

been fixed.

11850 Abnormal call termination due to misinterpreted SDP data

The SIP state machine in SmartWare had been modified to be stricter concerning the presence

of SDP in the following scenario:

 The SmartNode acts as a SIP UA client and send an INVITE

 An 1xx provisional response containing SDP is received (which allows for early media

to be set up)

 Any consecutive 1xx provisional response is then expected to contain SDP as well. If it

does not, the SDP offer/answer state machine is reset. This behavior results in an

abnormal call termination.

This behavior has been corrected and SmartWare does not expect any 1xx provisional

response to contain SDP anymore.

11852 Auto-provisioning: Target configuration without leading http or tftp

Until now it was mandatory to provide a „http://‟ or „tftp://‟ prefix while configuring an auto-

provisioning location. In cases where a location contains a placeholder for the dhcp 66 option,

these location configuring methods lead to following limitation: the dhcp option must not contain

protocol prefixes as otherwise replacement of this dhcp placeholder within a location may cause

protocol prefix repetition, thereby resulting in errors.

To overcome this problem, the auto-provisioning location feature has now been enhanced. It

now supports two new ways specifically meant for entering locations starting with the

placeholder for the dhcp 66 option and do not require any protocol prefixes.

For more details on how to configure auto-provisioning locations, please refer to the New

Configuration Commands section.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 40 41

Nessun commento

Zeck Audio STAC Force180 Guida di Installazione Pagina 17