Zeck Audio STAC Force180 Guida di Installazione Scaricare il pdf (Pagina 16)

Rev. 1.00 12-02-13 16/41

In this specific scenario a Fax transmission is detected based on the CED tone. The configured

T.38 fax relay protocol is negotiated and established between both SIP peers. Now SmartWare

received a T.38 CNG packet from the peer and killed its own T.38 transmission by misbehavior.

This misbehavior is now fixed and the T.38 CNG packet does not kill the Fax transmission

anymore.

11810 Auto-provisioning: redirection target reordering

When an auto-provisioning request to a location URI results in a redirection to another URI, the

SmartNode instead of trying the redirected URI tries the next location in the list. This was an

incorrect behavior and has now been fixed. From now on, the SmartNode will immediately try

the redirected URL first and only when this redirection fails will it continue with the next location

in its list of auto-provisioning locations.

11814 Missing strict-tei-procedure command

On the SN4660/70 device series the „[no] strict-tei-procedure‟ command was missing in ISDN‟s

q921 configuration mode. This command is now available.

11817 Provisioning: prevent downloading incompatible configuration

When a configuration file is downloaded from a provisioning server, the CLI major version of

this file is checked before applying the configuration. This is in order to prevent applying an

incompatible configuration. If no CLI version is present in the config file then it is considered

valid (to ensure no changes in current provisioning behavior).

SmartWare supports CLI version lower than 4 (current version is 3.20).

CLI version has the following syntax in configuration file:

cli version <major-version>.<minor-version>

11819 New provisioning placeholders

New placeholders have been added to the location command of a provisioning profile. This

allows for more flexible structures on the provisioning server. Please refer to the New

Configuration Commands section for further details about using these new placeholders.

11818 Auto-provisioning factory-config (Redirection service support)

The factory configuration file for the SmartNodes SN-DTA, SN4120 and SN4110 is updated to

provide support for Auto-provisioning redirection and for using locations containing placeholders

of dhcp option 66, 67

11832 Wrong G.S port state displayed

When the “show dsl all” command was executed on a SmartNode with a G.S interface the

“State” parameter always showed the wrong value. This came actually from “PeerPortState”.

Now the proper value is shown.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 40 41

Nessun commento

Zeck Audio STAC Force180 Guida di Installazione Pagina 16